Assembling the esp32 board
Your bord comes flashed with the lasted micropython. It includes our boot.py that creates a WiFi Access point called ESP-AP. The password is micropythoN. When you're connected, you can use a WebREPL to program your board. Just press enter when it asks for a password. There is none.
Just build it, like in the image below. Double check these:
- The orientation of the Buck converter. The 4R7 on the side of the 16 pin header.
- The orientation of the microphone. The icon faces upward and points toward the board.
- The orientation of the black 6 pin port. The small opening on the side should face inward.
- The switch is optional. You can reset via usb or power-cycle.
IMPORTANT NOTE! In the picture below, I did not add solder because I was in a hurry to get it photographed. To be clear: You DO need to solder it.
