-
-
Notifications
You must be signed in to change notification settings - Fork 360
Mesh Viewer
Miguel Risco-Castillo edited this page Dec 31, 2022
·
2 revisions
In the default Mesh Viewer, the numbers are relative to the home of Z axis (Z=0), the colors go from blue->turquoise->green->yellow->red, where green is for the points close to Z = 0. The size emulates dots following the perspective of an observer over the bed, big dots are close to the observer, small dots and far from the observer. If you create a mesh before printing in your start g-code, you can close the mesh viewer by writing the custom g-code C108 in a line after the G29 (G29 P1).
This Wiki and the included images were created under the Creative Commons License CC BY-NC-SA
Get the latest firmware here: https://github.com/mriscoc/Ender3V2S1/releases/latest